Gvrp Commands; Set Garp Timer Leaveall; Show Garp - NETGEAR M6100 Series Reference Manual

set garp timer leaveall

This command sets how frequently Leave All PDUs are generated. A Leave All PDU
indicates that all registrations will be unregistered. Participants would need to rejoin in order
to maintain registration. The value applies per port and per GARP participation. The time
may range from 200 to 6000 centiseconds. The value 1000 centiseconds is 10 seconds. You
can use this command on all ports (Global Config mode), or on a single port or a range of
ports (Interface Config mode) and it only has an effect only when GVRP is enabled. The
leave all time must be greater than the leave time.
Default 1000
Format
set garp timer leaveall centiseconds
Mode Interface Config
Global Config
no set garp timer leaveall
This command sets how frequently Leave All PDUs are generated the default and only has
an effect when GVRP is enabled.
Format
no set garp timer leaveall
Mode Interface Config
Global Config

show garp

This command displays GARP information.
Format
show garp
Mode Privileged EXEC
User EXEC
Term Definition
GMRP Admin The administrative mode of GARP Multicast Registration Protocol (GMRP) for the system.
Mode
GVRP Admin Mode The administrative mode of GARP VLAN Registration Protocol (GVRP) for the system.

GVRP Commands

This section describes the commands you use to configure and view GARP VLAN
Registration Protocol (GVRP) information. GVRP-enabled switches exchange VLAN
configuration information, which allows GVRP to provide dynamic VLAN creation on trunk
ports and automatic VLAN pruning.
M6100 Series Switches
Switching Commands
391