Dos-Control Tcpfinurgpsh; Dos-Control Icmpv - NETGEAR M6100 Series Reference Manual

no dos-control tcpsynfin
This command sets disables TCP SYN & FIN Denial of Service protection.
Format
no dos-control tcpsynfin
Mode Global Config

dos-control tcpfinurgpsh

This command enables TCP FIN and URG and PSH and SEQ = 0 checking Denial of Service
protections. If the mode is enabled, Denial of Service prevention is active for this type of
attack. If packets ingress having TCP FIN, URG, and PSH all set and TCP Sequence
Number set to 0, the packets will be dropped if the mode is enabled.
Default disabled
Format
dos-control tcpfinurgpsh
Mode Global Config
no dos-control tcpfinurgpsh
This command sets disables TCP FIN and URG and PSH and SEQ = 0 checking Denial of
Service protections.
Format
no dos-control tcpfinurgpsh
Mode Global Config

dos-control icmpv4

This command enables Maximum ICMPv4 Packet Size Denial of Service protections. If the
mode is enabled, Denial of Service prevention is active for this type of attack. If ICMPv4 Echo
Request (PING) packets ingress with a size greater than the configured value, the packets
are dropped if the mode is enabled. The value for the size is from 0–16376.
Default disabled (512)
Format
dos-control icmpv4 [size]
Mode Global Config
no dos-control icmpv4
This command disables Maximum ICMP Packet Size Denial of Service protections.
Format
no dos-control icmpv4
Mode Global Config
M6100 Series Switches
Switching Commands
565