Dhcp L2 Relay Agent Commands; Show Mac-Address-Table Staticfiltering - NETGEAR M6100 Series Reference Manual

show mac-address-table staticfiltering

This command displays the Static Filtering entries in the Multicast Forwarding Database
(MFDB) table.
Format
show mac-address-table staticfiltering
Mode Privileged EXEC
Term Definition
VLAN ID The VLAN in which the MAC Address is learned.
MAC Address A unicast MAC address for which the switch has forwarding and or filtering information. As the data
is gleaned from the MFDB, the address will be a multicast address. The format is 6 two-digit
hexadecimal numbers that are separated by colons, for example 01:23:45:67:89:AB.
Type The type of the entry. Static entries are those that are configured by the end user. Dynamic entries
are added to the table as a result of a learning process or protocol.
Description The text description of this multicast table entry.
Interfaces The list of interfaces that are designated for forwarding (Fwd:) and filtering (Flt:).

DHCP L2 Relay Agent Commands

You can enable the switch to operate as a DHCP Layer 2 relay agent to relay DHCP requests
from clients to a Layer 3 relay agent or server. The Circuit ID and Remote ID can be added to
DHCP requests relayed from clients to a DHCP server. This information is included in DHCP
Option 82, as specified in sections 3.1 and 3.2 of RFC3046.
dhcp l2relay
This command enables the DHCP Layer 2 Relay agent for an interface a range of interfaces
in, or all interfaces. The subsequent commands mentioned in this section can only be used
when the DHCP L2 relay is enabled.
Format
dhcp l2relay
Mode Global Config
Interface Config
no dhcp l2relay
This command disables DHCP Layer 2 relay agent for an interface or range of interfaces.
Format
no dhcp l2relay
Mode Global Config
Interface Config
M6100 Series Switches
Switching Commands
480