Multicast - NETGEAR M6100 Series Reference Manual

Table 62. VRRP Log Messages
Component Message
VRRP VRRP packet of size xxx dropped. Min VRRP
packet size is xxx;
Max VRRP packet size is xxx.
VRRP VR xxx on interface xxx started as xxx.
VRRP This router is the IP address owner for virtual
router xxx on interface xxx. Setting the virtual
router priority to xxx.
Table 63. ARP Log Message
Component Message
ARP IP address conflict on interface xxx for IP
address yyy. Conflicting host MAC address is
zzz.
Table 64. RIP Log Message
Component Message
RIP RIP: discard response from xxx via unexpected
interface

Multicast

Table 65. IGMP/MLD Log Messages
Component Message
IGMP/MLD MGMD Protocol Heap Memory Init Failed; Family
– xxx.
IGMP/MLD MGMD Protocol Heap Memory De-Init Failed;
Family – xxx.
M6100 Series Switches
NETGEAR Managed Switch Software Log Messages
1173
Cause
This message appears when there is flood of
VRRP messages in the network.
This message appears when the Virtual router is
started in the role of a Master or a Backup.
This message appears when the address
ownership status for a specific VR is updated. If
this router is the address owner for the VR, set
the VR's priority to MAX priority (as per RFC
3768). If the router is no longer the address
owner, revert the priority.
Cause
When an address conflict is detected for any IP
address on the switch upon reception of ARP
packet from another host or router.
Cause
When RIP response is received with a source
address not matching the incoming interface's
subnet.
Cause
MGMD Heap memory initialization Failed for the
specified address family. This message appears
when trying to enable MGMD Protocol.
MGMD Heap memory de-initialization Failed for
the specified address family. This message
appears when trying to disable MGMD
(IGMP/MLD) Protocol. As a result of this, the
subsequent attempts to enable/disable MGMD
will also fail.