Static Mac Filtering Commands; Show Vlan Remote-Span - NETGEAR M6100 Series Reference Manual

Term Definition
Dst Remote VLAN The destination VLAN is configured at the source switch. If the remote VLAN is not configured, this
field is blank.
IP ACL The IP access-list id or name attached to the port mirroring session.
MAC ACL The MAC access-list name attached to the port mirroring session.

show vlan remote-span

This command displays the configured RSPAN VLAN.
Format
show vlan remote-span
Mode Privileged Exec Mode
Command example:
(NETGEAR Switch)# show vlan remote-span
Remote SPAN VLAN
------------------------------------------------------------------------
100

Static MAC Filtering Commands

The commands in this section describe how to configure static MAC filtering. Static MAC
filtering allows you to configure destination ports for a static multicast MAC filter irrespective
of the platform.
macfilter
This command adds a static MAC filter entry for the MAC address macaddr on the VLAN
. The value of the macaddr parameter is a 6-byte hexadecimal number in the format of
vlanid
b1:b2:b3:b4:b5:b6. The restricted MAC Addresses are: 00:00:00:00:00:00,
01:80:C2:00:00:00 to 01:80:C2:00:00:0F, 01:80:C2:00:00:20 to 01:80:C2:00:00:21, and
FF:FF:FF:FF:FF:FF. The vlanid parameter must identify a valid VLAN.
The number of static mac filters supported on the system is different for MAC filters where
source ports are configured and MAC filters where destination ports are configured.
• For unicast MAC address filters and multicast MAC address filters with source port lists,
the maximum number of static MAC filters supported is 20.
• For multicast MAC address filters with destination ports configured, the maximum number
of static filters supported is 256.
For example, you can configure the following combinations:
• Unicast MAC and source port (max = 20)
M6100 Series Switches
Switching Commands
476