Neighbor Advertisement-Interval (Ipv6 Address Family Config); Neighbor Connect-Retry-Interval - NETGEAR M6100 Series Reference Manual

neighbor advertisement-interval (IPv6 Address Family Config)

In IPv6 Address Family mode, this command controls the time between sending Update
messages containing IPv6 routes.
NETGEAR Managed Switch BGP enforces the advertisement interval by limiting how often
phase 3 of the decision process can run for each update group. The interval applies to
withdrawals as well as active advertisements.
Default 30 seconds for external peers
5 seconds for internal peers
Format
neighbor ip-address advertisement-interval seconds
Mode IPv6 Address Family Config
Parameter Description
ip-address The neighbor's IP address.
seconds The minimum time between route advertisement, in seconds. The range is 0 to 600 seconds.
no neighbor advertisement-interval (IPv6 Address Family Config)
Use this command to return to the default the minimum time that must elapse between
advertisements of the same IPv6 route to a given neighbor.
Format
no neighbor ip-address advertisement-interval
Mode IPv6 Address Family Config

neighbor connect-retry-interval

Use this command in BGP Router Config mode to configure the initial connection retry time
for a specific neighbor. If a neighbor does not respond to an initial TCP connection attempt,
NETGEAR Managed Switch retries three times. The first retry is after the retry interval
configured with neighbor connect-retry-interval. Each subsequent retry doubles the previous
retry interval. So by default, the TCP connection is retried after 2, 4, and 8 seconds. If none of
the retries is successful, the adjacency is reset to the IDLE state and the IDLE hold timer is
started. BGP skips the retries and transitions to IDLE state if TCP returns an error, such as
destination unreachable, on a connection attempt.
Issue this command in Peer Template Configuration Mode to add it to a peer template.
Default
2 seconds
Format
neighbor ip-address connect-retry-interval retry-time
Mode BGP Router Config
M6100 Series Switches
Border Gateway Protocol Commands
820