Neighbor Route-Reflector-Client (Ipv6 Address Family Config); Neighbor Send-Community - NETGEAR M6100 Series Reference Manual

no neighbor route-reflector-client
Use this command in BGP Router Config mode to unconfigure an internal peer as an IPv4
route reflector client.
Format
no neighbor ip-address route-reflector-client
Mode BGP Router Config

neighbor route-reflector-client (IPv6 Address Family Config)

Use this command in IPv6 Address Family Config mode to configure an internal peer as an
IPv6 route reflector client.
Normally, a router does not readvertise BGP routes received from an internal peer to other
internal peers. If you configure a peer as a route reflector client, this router readvertises such
routes. A router is a route reflector if it has one or more route reflector clients. Configuring the
first route reflector client automatically makes the router a route reflector.
If you configure multiple route reflectors within a cluster, you must configure each route
reflector in the cluster with the same cluster ID. Use the
a cluster ID.
An external peer may not be configured as a route reflector client.
When reflecting a route, BGP ignores the set statements in an outbound route map to avoid
causing the receiver to compute routes that are inconsistent with other routers in the AS.
Default Peers are not route reflector clients.
Format
neighbor ip-address route-reflector-client
Mode IPv6 Address Family Config
Parameter Description
ip-address The neighbor's IPv4 or IPv6 address.
no neighbor route-reflector-client (IPv6 Address Family Config)
Use this command in IPv6 Address Family Config mode to unconfigure an internal peer as an
IPv6 route reflector client.
Format
no neighbor ip-address route-reflector-client
Mode IPv6 Address Family Config

neighbor send-community

To configure the local router to send the BGP community attributes in Update messages to a
specific neighbor, use the neighbor send-community command in BGP Router Config
mode or IPv6 Address Family Config mode.
M6100 Series Switches
Border Gateway Protocol Commands
834
bgp cluster-id command to configure