Switchport Protected (Interface Config) - NETGEAR M6100 Series Reference Manual

switchport protected (Global Config)
Use this command to create a protected port group. The groupid parameter identifies the
set of protected ports. Use the name parameter to assign a name to the protected port group.
The name can be up to 32 alphanumeric characters long, including blanks. The default is
blank.
Note: Port protection occurs within a single switch. Protected port
configuration does not affect traffic between ports on two different
switches. No traffic forwarding is possible between two protected
ports.
Default unprotected
Format
switchport protected groupid name name
Mode Global Config
no switchport protected (Global Config)
Use this command to remove a protected port group. The groupid parameter identifies the
set of protected ports. The name parameter specifies the name to remove from the group.
Format
no switchport protected groupid name name
Mode Global Config

switchport protected (Interface Config)

Use this command to add an interface to a protected port group. The groupid parameter
identifies the set of protected ports to which this interface is assigned. You can only configure
an interface as protected in one group.
Note: Port protection occurs within a single switch. Protected port configuration
does not affect traffic between ports on two different switches. No traffic
forwarding is possible between two protected ports.
Default unprotected
Format
switchport protected groupid
Mode Interface Config
M6100 Series Switches
Switching Commands
386