Spanning-Tree Vlan; Spanning-Tree Vlan Cost; Spanning-Tree Vlan Forward-Time - NETGEAR M6100 Series Reference Manual

no spanning-tree uplinkfast
This command disables uplinkfast on PVSTP configured switches. All switch priorities and
path costs that have not been modified from their default values are set to their default
values.
Format
no spanning-tree uplinkfast [max-update-rate]
Mode Global Config

spanning-tree vlan

Use this command to enable/disable spanning tree on a VLAN.
Default
None
Format
spanning-tree vlan vlan-list
Mode Global Config
Parameter Description
vlan-list The VLANs to which to apply this command.

spanning-tree vlan cost

Use this command to set the path cost for a port in a VLAN. The valid path cost values are in
the range of 1 to 200000000 or auto. If auto is selected, the path cost value is set based on
the link speed.
Default
None
Format
spanning-tree vlan vlan-id cost {auto | value}
Mode Interface Config

spanning-tree vlan forward-time

Use this command to configure the spanning tree forward delay time for a VLAN or a set of
VLANs. The default is 15 seconds.
Set this value to a lower number to accelerate the transition to forwarding. The network
operator should take into account the end-to-end BPDU propagation delay, the maximum
frame lifetime, the maximum transmission halt delay, and the message age overestimate
values specific to their network when configuring this parameter.
Default
15 seconds
Format
spanning-tree vlan vlan-list forward-time seconds
Mode Global Config
M6100 Series Switches
Switching Commands
345