Diffserv Class Commands - NETGEAR M6100 Series Reference Manual

Hide thumbs Also See for M6100 Series:

Table of Contents

definitions for all derived classes, otherwise the switch rejects the change. You can remove a

class reference from a class definition.

The only way to remove an individual match criterion from an existing class definition is to

delete the class and re-create it.

The mark possibilities for policing include CoS, IP DSCP, and IP

Precedence. While the latter two are only meaningful for IP packet

types, CoS marking is allowed for both IP and non-IP packets, since it

updates the 802.1p user priority field contained in the VLAN tag of the

layer 2 packet header.

This command sets the DiffServ operational mode to active. While disabled, the DiffServ

configuration is retained and can be changed, but it is not activated. When enabled, DiffServ

services are activated.

Global Config

This command sets the DiffServ operational mode to inactive. While disabled, the DiffServ

configuration is retained and can be changed, but it is not activated. When enabled, DiffServ

services are activated.

Global Config

DiffServ Class Commands

Use the DiffServ class commands to define traffic classification. To classify traffic, you specify

Behavior Aggregate (BA), based on DSCP and Multi-Field (MF) classes of traffic (name,

match criteria)

This set of commands consists of class creation/deletion and matching, with the class match

commands specifying Layer 3, Layer 2, and general match criteria. The class match criteria

are also known as class rules, with a class definition consisting of one or more rules to

identify the traffic that belongs to the class.

M6100 Series Switches

Quality of Service Commands

Table of Contents