Deleteport (Global Config) - NETGEAR M6100 Series Reference Manual

Note: Before you include a port in a port-channel, set the port physical
mode. For more information, see
Format
port-channel name
Mode Global Config
addport
This command adds one port to the port-channel (LAG). The first interface is a logical
unit/slot/port number of a configured port-channel. You can add a range of ports by
specifying the port range when you enter Interface Config mode (for example: interface
1/0/1-1/0/4. Instead of unit/slot/port, lag lag-intf-num can be used as an
alternate way to specify the LAG interface, in which lag-intf-num is the LAG port number.
Note: Before adding a port to a port-channel, set the physical mode of the
port. For more information, see
Format
addport logical unit/slot/port
Mode Interface Config
deleteport (Interface Config)
This command deletes a port or a range of ports from the port-channel (LAG). The interface
is a logical unit/slot/port number of a configured port-channel (or range of
port-channels). Instead of unit/slot/port, lag lag-intf-num can be used as an
alternate way to specify the LAG interface, in which lag-intf-num is the LAG port number.
Format
deleteport logical unit/slot/port
Mode Interface Config

deleteport (Global Config)

This command deletes all configured ports from the port-channel (LAG). The interface is a
logical unit/slot/port number of a configured port-channel. Instead of
unit/slot/port, lag lag-intf-num can be used as an alternate way to specify the
LAG interface, in which lag-intf-num is the LAG port number.
Format
deleteport {logical unit/slot/port | all}
Mode Global Config
M6100 Series Switches
speed on page 327.
speed on page 327.
Switching Commands
444