Table of Contents
Advertisement
NETGEAR 7000 Series Managed Switch Administration Guide Version 7.3
a.
From the main menu, select Routing > OSPF > Advanced> Interface Configuration. A screen
similar to the following displays.
Figure 9-7
b. Under Interface Configuration, scroll down to interface 1/0/3 and select the checkbox for that
interface. 1/0/3 now appears in the Interface field at the top.
•
In the OSPF Area ID field, enter 0.0.0.3.
•
Select the Enable from the OSPF Admin Mode pull-down menu.
•
In the Priority field, enter 255.
•
In the Metric Cost field, enter 64.
c.
Click Apply to save the settings.
Configure OSPF on a Border Router
The example is shown as CLI commands and as a Web interface procedure. For an OSPF example network,
see
Figure 9-1 on page
9-2.
CLI: Configuring OSPF on a Border Router
Enable routing for the switch.
(Netgear Switch) #config
(Netgear Switch) (Config)#ip routing
9-8
v1.0, November 2008
OSPF
Advertisement
Table of Contents
