Ip Address - NETGEAR M6100 Series Reference Manual

no ip routing
This command disables the IP Router Admin Mode for the supervisor blade.
Format
no ip routing
Mode Global Config

ip address

This command configures an IP address on an interface or range of interfaces. You can also
use this command to configure one or more secondary IP addresses on the interface. The
command supports RFC 3021 and accepts using 31-bit prefixes on IPv4 point-to-point links.
This command adds the label IP address in the command
Note: The 31-bit subnet mask is only supported on routing interfaces. The
feature is not supported on network port and service port interfaces
because NETGEAR Managed Switch acts as a host, not a router, on
these management interfaces.
Format
ip address ipaddr {subnetmask | /masklen} [secondary]
Mode Interface Config
Parameter Description
ipaddr The IP address of the interface.
subnetmask A 4-digit dotted-decimal number which represents the subnet mask of the interface.
masklen Implements RFC 3021. Using the / notation of the subnet mask, this is an integer that indicates the
length of the subnet mask. Range is 5 to 32 bits.
Command example:
The following example configures the subnet mask with an IP address in the dotted decimal
format on interface 0/4/1.
(NETGEAR Switch) #config
(NETGEAR Switch) (Config)#interface 0/4/1
(NETGEAR Switch) (Interface 0/4/1)#ip address 192.168.10.1 255.255.255.254
M6100 Series Switches
Routing Commands
629
show ip interface on page 637.