Internet Group Message Protocol Commands; Ip Igmp - NETGEAR M6100 Series Reference Manual

Command example:
(NETGEAR) # show ip pim rp mapping candidate
RP Address.................................... 192.168.10.1
Group Address.............................. 224.1.2.1
Group Mask................................. 255.255.0.0
Origin..................................... BSR
C-RP Advertisement Interval (secs)......... 60
Next Candidate RP Advertisement (hh:mm:ss). 00:00:15
Command example:
If no RP Group mapping exist on the router, the following message is displayed:
No RP-Group mappings exist on this router.

Internet Group Message Protocol Commands

This section describes the commands you use to view and configure Internet Group Message
Protocol (IGMP) settings.

ip igmp

This command sets the administrative mode of IGMP in the system to active on an interface,
range of interfaces, or on all interfaces.
Default disabled
Format
ip igmp
Modes Global Config
Interface Config
no ip igmp
This command sets the administrative mode of IGMP in the system to inactive.
Format
no ip igmp
Modes Global Config
Interface Config
M6100 Series Switches
IP Multicast Commands
1096