number argument is a number in the range 1–5. The default is 0, or no lockout count
enforced.
Default
0
Format
passwords lock-out number
Mode
Global Config
no passwords lock-out
Use this command to set the password lock-out count to the default value.
Format
no passwords lock-out
Mode
Global Config
passwords strength-check
Use this command to enable the password strength feature. It is used to verify the strength of
a password during configuration.
Default
Disable
Format
passwords strength-check
Mode
Global Config
no passwords strength-check
Use this command to set the password strength checking to the default value.
Format
no passwords strength-check
Mode
Global Config
passwords strength maximum consecutive-characters
Use this command to set the maximum number of consecutive characters to be used in
password strength. The number argument is a number in the range 0–15. The default is 0.
Minimum of 0 means no restriction on that set of characters.
Default
0
Format
passwords strength maximum consecutive-characters number
Mode
Global Config
M6100 Series Switches
Management Commands
96