Serial Timeout; Set Sup-Console; Show Serial - NETGEAR M6100 Series Reference Manual

serial timeout

This command specifies the maximum connect time (in minutes) without console activity. A
value of 0 indicates that a console can be connected indefinitely. The time range is 0 to 160.
Default 5
Format
serial timeout 0-160
Mode Line Config
no serial timeout
This command sets the maximum connect time (in minutes) without console activity.
Format
no serial timeout
Mode Line Config

set sup-console

This command allows access to the full CLI from any blade. By default, the supervisor is
allowed full CLI access. You can move full CLI access among the blades, but at any time,
only one blade can access the management CLI. You can issue the command on the
member or backup blade. After the console is transferred to the backup blade or to a member
blade, access to the full CLI on the supervisor is disabled to avoid multiple simultaneous CLI
inputs. You can restore full access on the supervisor by entering the command at the
supervisor serial port.
Note: Entering the command while the supervisor has full CLI access has
no effect.
Format
set sup-console
Mode Privileged EXEC

show serial

This command displays serial communication settings for the switch.
Format
show serial
Modes • Privileged EXEC
• User EXEC
M6100 Series Switches
Management Commands
55