Show (Privileged Exec) - NETGEAR M6100 Series Reference Manual

Parameter Description
interface Running configuration for the specified interface.
lag-intf-num Running configuration for the LAG interface.
loopback-id Running configuration for the loopback interface.
tunnel-id Running configuration for the tunnel interface.
vlan-id Running configuration for the VLAN routing interface.
The following information is displayed for the command.
Parameter Description
unit|slot|port Enter an interface in unit/slot/port format.
lag Display the running config for a specified lag interface.
loopback Display the running config for a specified loopback interface.
tunnel Display the running config for a specified tunnel interface.
vlan Display the running config for a specified vlan routing interface.
Command example:
(NETGEAR Switch) #show running-config interface 0/1
!Current Configuration:
!
interface 0/1
addport 3/1
exit
(NETGEAR Switch) #

show (Privileged EXEC)

This command displays the content of text-based configuration files from the CLI. The
text-based configuration files (startup-config, backup-config and factory-defaults) are saved
compressed in flash. With this command, the files are decompressed while displaying their
content.
Format
show {startup-config | backup-config | factory-defaults}
Mode Privileged EXEC
Parameter Description
startup-config Display the content of the startup-config file.
M6100 Series Switches
Utility Commands
173