Serviceport Protocol; Serviceport Ip; Serviceport Protocol Dhcp - NETGEAR M6100 Series Reference Manual

serviceport ip

This command sets the IP address, the netmask, and the gateway of the network
management port. You can specify the none option to clear the IPv4 address and mask and
the default gateway (that is, reset each of these values to 0.0.0.0).
Format
serviceport ip {ipaddr netmask [gateway] | none}
Mode Privileged EXEC

serviceport protocol

This command specifies the network management port configuration protocol. If you modify
this value, the change is effective immediately. If you use the
periodically sends requests to a BootP server until a response is received. If you use the
parameter, the switch periodically sends requests to a DHCP server until a response is
received. If you use the
switch manually.
Format
serviceport protocol {none | bootp | dhcp}
Mode Privileged EXEC

serviceport protocol dhcp

This command enables the DHCPv4 client on a Service port. If the client-id optional
parameter is given, the DHCP client messages are sent with the client identifier option.
Default none
Format
serviceport protocol dhcp [client-id]
Mode Privileged Exec
There is no support for the no form of the command serviceport protocol dhcp
client-id. To remove the client-id option from the DHCP client messages, issue the
command serviceport protocol dhcp without the client-id option. The command
serviceport protocol none can be used to disable the DHCP client and client-id option
on the interface.
Command example:
(NETGEAR Switch) # serviceport protocol dhcp client-id
M6100 Series Switches
parameter, you must configure the network information for the
none
Management Commands
48
parameter, the switch
bootp
dhcp