Environment Trap; Debug Environment - NETGEAR M6100 Series Reference Manual

Parameter Definition
min temperature Sets the minimum allowed temperature for normal operation. The range is between
– 100°C and 100°C. The default is 0°C.
max temperature Sets the maximum allowed temperature for normal operation. The range is between
– 100°C and 100°C. The default is 0°C.

environment trap

Use this command to configure environment status traps.
Format
environment trap {fan | powersupply | temperature}
Mode Global Config
Parameter Definition
fan Enables or disables the sending of traps for fan status events. The default is enable.
powersupply Enables or disables the sending of traps for power supply status events. The default is enable.
temperature Enables or disables the sending of traps for temperature status events. The default is enable.

debug environment

This command displays the error logs, including information such as zero temperature
reading, number of resets, and power module failures on the switch since the last time it was
rebooted.
Note: To display the debug trace, enable the
Format
debug environment
Mode Privileged EXEC
Command example:
(NETGEAR Switch) #debug environment
Temperature Sensors:
Slot Sensor id # of Reset
1 1
2 1
3 1
Power supplies:
Module Failures
------ --------
1 0
2 0
3 0
M6100 Series Switches
debug console
0
1
0
Utility Commands
180
command.