Radius Server Timeout; Show Radius - NETGEAR M6100 Series Reference Manual

Parameter Description
unit/slot/port The unit identifier assigned to the switch.
loopback-id Configures the loopback interface. The range of the loopback ID is 0 to 7.
vlan-id Configures the VLAN interface to use as the source IP address. The range of the VLAN ID is 1 to
4093.
no radius source-interface
Use this command to reset the RADIUS source interface to the default settings.
Format
no radius source-interface
Mode Global Config

radius server timeout

This command configures the global parameter for the RADIUS client that specifies the
time-out value (in seconds) after which a request must be retransmitted to the RADIUS
server if no response is received. The time-out value is an integer in the range of 1 to 30
seconds.
Default 5
Format
radius server timeout seconds
Mode Global Config
Field Description
retries Maximum number of transmission attempts in the range 1–30.
no radius server timeout
The no version of this command sets the timeout global parameter to the default value.
Format
no radius server timeout
Mode Global Config

show radius

This command displays the values configured for the global parameters of the RADIUS
client.
Format
show radius
Mode Privileged EXEC
M6100 Series Switches
Management Commands
125