Port (Mail Server Config); Username (Mail Server Config); Password (Mail Server Config) - NETGEAR M6100 Series Reference Manual

no mail-server
This command removes the specified SMTP server from the configuration.
Format
no mail-server {ip-address | ipv6-address | hostname}
Mode Global Config
security
This command sets the email alerting security protocol by enabling the switch to use TLS
authentication with the SMTP Server. If the TLS mode is enabled on the switch but the SMTP
sever does not support TLS mode, no email is sent to the SMTP server.
Default none
Format
security {tlsv1 | none}
Mode Mail Server Config

port (Mail Server Config)

This command configures the TCP port to use for communication with the SMTP server. The
recommended port number for TLSv1 is 465, and for no security that is, none) it is port
number 25. However, any nonstandard port number in the range 1 to 65535 is also allowed.
Default 25
Format
port number
Mode Mail Server Config

username (Mail Server Config)

This command configures the login ID the switch uses to authenticate with the SMTP server.
Default admin
Format
username name
Mode Mail Server Config

password (Mail Server Config)

This command configures the password the switch uses to authenticate with the SMTP
server.
Default admin
Format
password password
Mode Mail Server Config
M6100 Series Switches
Utility Commands
194