Logging Commands; Logging Buffered; Debug I2C; Logging Buffered Wrap - NETGEAR M6100 Series Reference Manual

4 0
5 0
6 0
7 0
8 0

debug i2c

This command displays information about the health and statistics of the i2c bus. The slot
parameter specifies the slot in which a blade is installed.
Note: To display the debug trace, enable the
Format
debug i2c slot
Mode Privileged EXEC

Logging Commands

This section describes the commands you use to configure system logging, and to view logs
and the logging settings.

logging buffered

This command enables logging to an in-memory log.
Default disabled; critical when enabled
Format
logging buffered
Mode Global Config
no logging buffered
This command disables logging to in-memory log.
Format
no logging buffered
Mode Global Config

logging buffered wrap

This command enables wrapping of in-memory logging when the log file reaches full
capacity. Otherwise when the log file reaches full capacity, logging stops.
Default enabled
Format
logging buffered wrap
Mode Privileged EXEC
M6100 Series Switches
debug console
Utility Commands
181
command.