Gvrp Commands; Set Gvrp Adminmode; Set Gvrp Interfacemode - NETGEAR ProSafe GSM7324 Command Line Interface Reference Manual
Prosafe 7300 series layer-3 switches, software version 4.0
Hide thumbs
Also See for ProSafe GSM7324:
- Reference manual (263 pages) ,
- Installation manual (26 pages) ,
- Brochure & specs (2 pages)
Table of Contents
Advertisement
Command Line Interface Reference for the ProSafe 7300 Series Layer-3 Switches, Software Ver-
GVRP Admin
Mode
8.2 GVRP Commands
This section describes the commands you use to configure and view GARP VLAN
Registration Protocol (GVRP) information. GVRP-enabled switches exchange VLAN
configuration information, which allows GVRP to provide dynamic VLAN creation on
trunk ports and automatic VLAN pruning.
Note: If GVRP is disabled, the system does not forward GVRP messages.
8.2.1 set gvrp adminmode
This command enables GVRP.
Default
Format
Mode
8.2.1.1 no set gvrp adminmode
This command disables GVRP.
Format
Mode
8.2.2 set gvrp interfacemode
This command enables GVRP.
Default
Format
Modes
GARP, GVRP, and GMRP Commands
This displays the administrative mode of GVRP for the sys-
tem
disabled
set gvrp adminmode
Privileged EXEC
no set gvrp adminmode
Privileged EXEC
disabled
set gvrp interfacemode
Interface Config
Global Config
v1.0, December 2005
8-5
Advertisement
Chapters
Table of Contents
