Set Port Auto-Negotiation-Flowcontrol-Advertisement; Set Port Channel - Avaya P460 Reference Manual

set port auto-negotiation-flowcontrol-advertisement

User level: read-write, admin.
Use the set port auto-negotiation-flowcontrol-advertisement
command to set the flowcontrol advertisement for a Gigabit port when performing
autonegotiation.
The syntax for this command is:
set port auto-negotiation-flowcontrol-advertisement <module>/
<port> {no-flowcontrol|asym-tx-only|sym-only|sym-and-asym-rx}
module
port
no-flowcontrol
asym-tx-only
sym-only
sym-and-asym-rx
Example:
P460-1# set port auto-negotiation-flowcontrol-
advertisement 2/5 asym-tx-only
Port 2/5 pause capabilities was set

set port channel

User level: read-write, admin.
Enables or disables a Link Aggregation Group (LAG) interface on the switch. LAG
creation requires a LAG name to be specified. There is no default name.
You can also add or remove a port from an existing LAG. All ports in the LAG are
configured with the parameters of the first port that is added to the LAG. These
parameters include port administrative status, speed, duplex, autonegotiation
mode, VLAN ID, tagging mode, binding mode, and priority level. When adding a
port to an existing LAG, the user must type the same LAG-name (or no LAG-name),
otherwise you will get an error message.
Avaya P460 Reference Guide
Number of the module (3-6).
Number of the port on the module. If you do not specify a
number, all the ports on the module are set.
You can also specify a range of ports separated by a dash, for
example, 4/5-13 for ports 5 to 13 on module 4.
The port will advertise no pause capabilities.
The port will advertise asymmetric Tx pause capabilities only.
The port will advertise symmetric pause capabilities only.
The port will advertise both symmetric and asymmetric Rx
pause capabilities.
Chapter 2 Avaya P460 CLI Commands
85