Interface Mode; Ip Address Command; Ip Vlan/Ip Vlan Name Commands - Avaya P333R-LB User Manual

Chapter 6 Cajun Campus CLI - Layer 3

Interface Mode

ip address Command

Use the ip address command to assign an IP address and mask to an interface.
The syntax for this command is:
ip address <ip-address> <mask> [<admin-state>]
ip address
mask
admin-state
Example:
To assign the IP address 192.168.22.33 with mask 255.255.255.0 to the interface
"marketing":
Router-N(config-if:marketing)# ip address 192.168.22.33
255.255.255.0

ip vlan/ip vlan name Commands

Use these commands to specify the VLAN on which an IP interface resides. You
can specify either the VLAN ID using the ip vlan command or the vlan name using
the ip vlan name command. The no form of the command restores the IP interface to
the default VLAN.
The syntax for this command is:
[no] ip vlan <vlan-id>
or
[no] ip vlan name <vlan-Name>
Example:
To specify vlan developmental as the vlan used by interface "products":
Router-N(config-if:marketing)# ip vlan name development
Note: If you wish to define a name which includes spaces, you must enclose the
entire name in quotation marks, e.g. "new york".
166
The IP address assigned to the interface.
Mask for the associated IP subnet
The administration status – either Up or Down
Avaya P333R-LB User's Guide