Ip Access-Default-Action; Ip Access-Group - Avaya P460 Reference Manual

The syntax for this command is:
[no] interface <interface name>
interface name
Example:
Router-1(configure)# interface marketing
Done!
Router-1(config-if:marketing)#
If you wish to define a name which includes spaces, you must enclose the entire
name in quotation marks, for example "new york".

ip access-default-action

User level: read-write, admin.
• You can only access this command in Configure mode.
Type configure at the command prompt to enter Configure mode if
necessary.
Use the ip access-default-action command to set the default action for a
specific policy list.
The syntax for this command is:
ip access-default-action <policy-list-number> <default-
action>
<policy-list-number>
<default-action>
Example:
Router-1(configure)# access-default-action 101 default-
action-deny

ip access-group

User level: read-write, admin.
• You can only access this command in Configure mode.
Type configure at the command prompt to enter Configure mode.
Avaya P460 Reference Guide
Chapter 2
String (up to 32 characters)
integer (100...199)
default-action-deny|default-action-permit
Avaya P460 CLI Commands
31