SNMP Commands
Show snmp Command
Use the show snmp command to display SNMP information.
The syntax for this command is:
show snmp
Example:
P130-N> show snmp
Authentication trap disabled
Community-Access
----------------
read-only
read-write
trap
Trap-Rec-Address
----------------
1.1.1.1
etc...
Show snmp retries Command
Use the show snmp retries command to display the number of retries initiated
by the Device Manager application when it tries to send SNMP messages to the
device.
The syntax for this command is:
show snmp retries
Example:
P130-N> show snmp retries
the SNMP Retries Number is 3
Avaya P130 User's Guide
Community-String
----------------
public
public
public
Traps Enabled
----------------
config
fault
Chapter 6
Avaya P130 CLI
113