Show Snmp Retries; Show Snmp Timeout; Show Spantree - Avaya P460 Reference Manual

show snmp retries

User level: read-only, read-write, admin.
Use the show snmp retries command to display the number of retries initiated
by the P460 Manager when it tries to send SNMP messages to the device.
The syntax for this command is:
show snmp retries
Example:
P460-1> show snmp retries
the SNMP Retries Number is 3

show snmp timeout

User level: read-only, read-write, admin.
Use the show snmp timeout command to display the default SNMP timeout in
seconds.
Tip: This command is useful for access using the Device Manager.
The syntax for this command is:
show snmp timeout
Example:
P460-1> show snmp timeout
the SNMP Timeout is 2000

show spantree

User level: read-only, read-write, admin.
Use then show spantree command to display spanning-tree information.
The syntax for this command is:
show spantree [<module>[/<port>]]
module
(Optional)
Avaya P460 Reference Guide
Number of the module. If you do not specify a number, all
modules are shown.
Chapter 2 Avaya P460 CLI Commands
171