Intermodule Port Redundancy; Port Redundancy Cli Commands - Avaya P334T-ML Installation and configuration guid Installation And Configuration Manual

Intermodule Port Redundancy

The intermodule port redundancy feature supports one pair of redundant ports per
stack. The secondary port is activated:
• when the primary port link is down, or
• when the module in the stack holding the primary port has been powered down
or removed.
Switching time for intermodule port redundancy is approximately 1 second.
Defining intermodule port redundancy on ports with no link causes both ports
to be disabled. You should connect the link prior to attempting to define
intermodule port redundancy.
Once a port has been designated in a redundancy scheme, either as a primary or
a secondary port, it can not be designated in any other redundancy scheme.
Intermodule Port Redundancy does not interworks with the Spanning Tree
Algorithm.

Port Redundancy CLI Commands

The following table contains a list of the CLI commands for the Redundancy feature.
The rules of syntax and output examples are all set out in detail in the P330 Reference
Guide.
In order to...
Define or remove port redundancy
schemes
Enable the defined port
redundancy schemes
Disable the defined port
redundancy schemes
Define the timers that control the
port redundancy operation
Display information on port
redundancy schemes.
Define the switch's unique
intermodule redundancy scheme
Clear the intermodule redundancy
Avaya P334T-ML User's Guide
Chapter 11 Avaya P330 Layer 2 Features
Use the following command...
set port redundancy
set port redundancy enable
set port redundancy disable
set port redundancy-interval
show port redundancy
set intermodule port redundancy
set intermodule port redundancy
off
103