Set Ppp Authentication Incoming Command; Set Ppp Incoming Timeout Command; Set Ppp Baud-Rate Command - Avaya P333R-LB User Manual

Chapter 5 Cajun Campus CLI – Layer 2

Set ppp authentication incoming Command

Use the set ppp authentication incoming command to define the
authentication method used for a PPP server or client session.
The syntax for this command is:
set ppp authentication incoming <pap|chap|none>
pap
chap
none
Example:
P330-N(super)# set ppp authentication incoming chap

Set ppp incoming timeout Command

Use the set ppp incoming timeout command to configure the number of
minutes until the system automatically disconnects an idle PPP incoming session.
The syntax for this command is:
set ppp incoming timeout <timeout>
timeout
Example:
P330-N> set ppp incoming timeout 15
PPP incoming session will automatically disconnect after 15
minutes of idle time

Set ppp baud-rate Command

Use the set ppp baud-rate command to define the baud rate used in PPP sessions.
Note that the peer baud rate must be set at the same value as the host.
The syntax for this command is:
set ppp baud-rate <9600 | 19200 | 38400>
Example:
P330-N# set ppp baud-rate 38400
120
PAP authentication method
CHAP authentication method
No authentication
The timeout in minutes.
Avaya P333R-LB User's Guide