Ip Ospf Authentication-Key - Enterasys Matrix 2G4072-52 Configuration Manual

Routing Protocol Configuration Command Set
Configuring OSPF

13.2.3.11 ip ospf authentication-key

Use this command to assign a password to be used by neighboring routers using OSPF's simple
password authentication. This password is used as a "key" that is inserted directly into the OSPF
header in routing protocol packets. A separate password can be assigned to each OSPF network on
a per-interface basis.
ip ospf authentication-key password
NOTES: The password key set with this command will only be used when
authentication is enabled for an OSPF area using the area authentication command
described in
All neighboring routers on the same network must have the same password configured
to be able to exchange OSPF information.
Syntax Description
password
Command Syntax of the "no" Form
The "no" form of this command removes an OSPF authentication password on an
interface:
no ip ospf authentication-key
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
If password is not specified, the password will be set to a blank string.
Example
This example shows how to enables an OSPF authentication key on VLAN 1 with the password
"yourpass":
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip ospf authentication-key yourpass
13-44 Matrix DFE-Platinum and Diamond Series Configuration Guide
Section 13.2.3.15.
Specifies an OSPF authentication password. Valid values
are alphanumeric strings up to 8 bytes in length.