Ip Ospf Retransmit-Interval - Enterasys Matrix 2G4072-52 Configuration Manual

Routing Protocol Configuration Command Set
Configuring OSPF
13.2.3.7

ip ospf retransmit-interval

Use this command to set the amount of time between retransmissions of link state advertisements
(LSAs) for adjacencies that belong to an interface.
ip ospf retransmit-interval seconds
Syntax Description
seconds
Command Syntax of the "no" Form
The "no" form of this command resets the retransmit interval value to the default,
5 seconds:
no ip ospf retransmit-interval
Command Type
Router command.
Command Mode
Interface configuration: Matrix>Router1(config-if(Vlan 1))#
Command Defaults
None.
Example
This example shows how to set the OSPF retransmit interval for VLAN 1 to 20:
Matrix>Router1(config)#interface vlan 1
Matrix>Router1(config-if(Vlan 1))#ip ospf retransmit-interval 20
13-40 Matrix DFE-Platinum and Diamond Series Configuration Guide
Specifies the retransmit time in seconds. Valid values are 1
to 65535.