excess cable out of the way in a neatly coiled loop in the cable management system. Placing fasteners
on the loop helps to maintain its shape.
CAUTION:
allow fastened loops of cable to dangle, which stresses the cable at the fastening
point.
CAUTION:
An arc smaller than a few inches in diameter can damage the cable and cause
problems that are difficult to diagnose.
7. Verify that the status LEDs on the router indicate that the QSFP28 transciever is functioning correctly.
You can also verify interface port functioning by issuing the show chassis fpc pic-status command.
Replacing a CFP2 Transceiver
IN THIS SECTION
Removing a CFP2 Transceiver | 133
Installing a CFP2 Transceiver | 134
Do not let fiber-optic cable hang free from the connector. Do not
Avoid bending fiber-optic cable beyond its minimum bend radius.
132