Replacing An Mx104 Transceiver; Removing An Mx104 Transceiver; Figure 43: Installing A Routing Engine - Juniper MX104 Hardware Manual

Related
Documentation

Replacing an MX104 Transceiver

Removing an MX104 Transceiver

Copyright © 2014, Juniper Networks, Inc.
Temperature
CPU Temperature
If the router is operational and the Routing Engine is functioning properly, the state
shows
Online Master
chassis routing-engine CLI command, see show chassis environment routing-engine.

Figure 43: Installing a Routing Engine

MX104 Routing Engine Overview on page 20
Maintaining the MX104 Routing Engines on page 76
Small form-factor pluggable transceivers (SFPs) are optical transceivers that are installed
in the front panel of the MX104 router. Transceivers are hot-insertable and hot-removable.
Removing an MX104 Transceiver on page 109
1.
Installing an MX104 Transceiver on page 111
2.
Removing a transceiver does not interrupt router functioning, but the removed transceiver
no longer receives or transmits data.
To remove a transceiver (see
Have ready a replacement transceiver or a transceiver slot plug, an antistatic mat,
1.
and a rubber safety cap for the transceiver.
Attach an ESD grounding strap to your bare wrist and connect the strap to one of the
2.
ESD points on the chassis.
Label the cables connected to the transceiver so that you can reconnect them correctly
3.
later.
Chapter 13: Replacing MX104 Hardware Components
33 degrees C / 91 degrees F
39 degrees C / 102 degrees F
or . For more information about using the show
Online Standby
Figure 44 on page 110):
109