CHAPTER 26
Replacing Power System Components
Replacing an MX240 AC Normal-Capacity Power Supply
Removing an MX240 AC Normal-Capacity Power Supply
Copyright © 2016, Juniper Networks, Inc.
Replacing an MX240 AC Normal-Capacity Power Supply on page 315
Replacing an MX240 AC Power Supply Cord on page 317
Replacing an MX240 DC Normal-Capacity Power Supply on page 318
Replacing an MX240 DC Power Supply Cable on page 322
Removing an MX240 AC Normal-Capacity Power Supply on page 315
1.
Installing an MX240 AC Normal-Capacity Power Supply on page 316
2.
Before you remove a power supply, be aware of the following:
NOTE:
The minimum number of power supplies must be present in the router
at all times.
CAUTION:
To maintain proper cooling and prevent thermal shutdown of the
operating power supply unit, each power supply slot must contain either a
power supply or a blank panel. If you remove a power supply, you must install
a replacement power supply or a blank panel shortly after the removal.
NOTE:
After powering off a power supply, wait at least 60 seconds before
turning it back on.
315