Replacing Power System Components; Replacing An Mx240 Ac Normal-Capacity Power Supply; Removing An Mx240 Ac Normal-Capacity Power Supply - Juniper MX240 Hardware Manual

3d universal edge router

Hide thumbs Also See for MX240:

Table of Contents

Replacing Power System Components

Replacing an MX240 AC Normal-Capacity Power Supply on page 335

Replacing an MX240 AC Power Supply Cord on page 337

Replacing an MX240 DC Normal-Capacity Power Supply on page 338

Replacing an MX240 DC Power Supply Cable on page 343

Removing an MX240 AC Normal-Capacity Power Supply on page 335

Installing an MX240 AC Normal-Capacity Power Supply on page 336

Before you remove a power supply, be aware of the following:

The minimum number of power supplies must be present in the router

at all times.

To maintain proper cooling and prevent thermal shutdown of the

operating power supply unit, each power supply slot must contain either a

power supply or a blank panel. If you remove a power supply, you must install

a replacement power supply or a blank panel shortly after the removal.

After powering off a power supply, wait at least 60 seconds before

turning it back on.