Installing An Mx2020 Adapter Card; Figure 145: Installing An Ac Power Supply Module - Juniper MX2020 Hardware Manual

Related
Documentation

Installing an MX2020 Adapter Card

Copyright © 2015, Juniper Networks, Inc.

Figure 145: Installing an AC Power Supply Module

Preventing Electrostatic Discharge Damage to an MX2020 Router on page 558
MX2020 AC Power Supply Module Description on page 158
MX2020 AC Power Subsystem Electrical Specifications on page 158
Removing an MX2020 AC Power Supply Module on page 428
An ADC weighs up to 15 lb (6.80 kg). Be prepared to accept its full weight.
To install an ADC (see Figure 146 on page
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Remove the ADC from its electrostatic bag.
2.
Identify the slot on the router where it will be installed.
3.
Orient the ADC so that the faceplate faces you vertically.
4.
Lift the ADC into place, and carefully align the sides of the ADC with the guides inside
5.
the card cage.
Chapter 22: Installing and Replacing Components
296):
295