Rs-232C (Option); Figure 3-2 Typical Setup For Automated Test System (Gp-Ib Interface) - Agilent Technologies N9360A Programming Manual

Figure 3-2 Typical Setup for Automated Test System (GP-IB Interface)

RS-232C (Option)

N9360A Multi UE Tester W-CDMA Programming Manual
• An IEEE-488 (GP-IB) cable.
• An RF cable to connect the RF signals from or to the mobile
phone under test, the Antenna Coupler (Agilent CAU-17) to
connect the RF signals from or to the mobile phone to couple
the RF signals from or to the mobile phone.
• Printer and an appropriate cable (if required).
A typical setup for an automated test system using the GP-IB as
shown in Figure 3-2 below:
The following equipments are required to construct an
automated test system using RS-232C:
• The Agilent N9360A Multi UE Tester.
• A system controller with the RS-232C interface.
• An RS-232C null modem cable.
• An RF cable to connect the RF signals from or to the mobile
phone under test, the Antenna Coupler (Agilent CAU-17) to
connect the RF signals from or to the mobile phone to couple
the RF signals from or to the mobile phone.
• Printer and an appropriate cable (if required).
A typical setup for an automated test system using RS-232C as
shown in Figure 3-3 below:
3
Preparing for Use
3-3