Figure 4-1 [Configuration] Screen (Ethernet Interface) - Agilent Technologies N9360A Programming Manual

4
Programming Command Guidelines
The terminator outputted from the Tester can be changed as
specified in Table 4-1.
The terminator inputted to the Tester is LF (fixed).
The TCP port number is 10123 (fixed).
Refer to the following procedure to set the Ethernet
configuration.
Step 1
On the [Initial screen], press the Config softkey to obtain the
[Configuration] screen.

Figure 4-1 [Configuration] Screen (Ethernet Interface)

Step 2
Confirm that the Ethernet configurations are correct.
Step 3
Reboot the Tester to activate the configuration.
N9360A Multi UE Tester W-CDMA Programming Manual 4-5