Agilent Technologies 6890 Series Service Manual page 584

1010 Cabling Diagrams, 6890A and
6890 Plus
Overview of 6890 GC cable connections
There are numerous system configurations available with the 6890 GC, and
your cabling requirements will be determined by the system's components.
In the figures that follow, refer to the configuration most closely resembling
your system.
Remote start-stop for communication with
3395/3396 integrators, GC ALS, Mass Selective
Detector, 35900 C/D/E analog/digital interface
and other GCs
OR
INET card for
LAN card for
3396B/C
a networked
integrators
Chemserver
RS-232 for Controller,18594 A/B or
G1512A, GC Automatic Liquid Sampler
(GC ALS)
Figure 1010-1
Jun 2001
Connectors on the back of the GC
Cabling Configuration and Electronics
Agilent 6890 Gas Chromatograph Service Manual
RS-232 for modem or non-Agilent
controller
Analog output for integrators or analog
to digital (A/D) converters
Power and communication for front
G2613A Injector
Power and communication for back
G2613A Injector
Power and communication for
G2614A tray
External event for communication with
unspecified, non-Agilent instruments
BCD input for stream selection valves
and some non-Agilent headspace samplers
General Purpose Interface Bus (GPIB) for
ChemStation
1 of 14