O-ring
Figure 350-13
6.
Remove the ignitor cable.
7.
Unscrew the connector and ignitor assembly from the detector module.
8.
Remove the O-ring, ignitor spacer, and glow plug from the ignitor
assembly. Replace the glow plug. Inspect the O-ring and spacer, and
replace if needed.
9.
Reassemble in reverse order.
Jun 2001
Spacer
Glow plug
Connector
Ignitor cable
Replacing the ignitor glow plug
Detectors
Agilent 6890 Gas Chromatograph Service Manual
Flame Photometric Detector (FPD)
Replacement procedures
350
Ignitor cable
23 of 36