Agilent Technologies 6890 Series Service Manual page 49

210 Split/Splitless Inlet
Replacement procedures
4. Pull the inlet up out of the inlet carrier. If necessary, you can also slide
the insulation sleeve off of the bottom of the inlet.
Heater/sensor
Torx T-20
Figure 210-6
10 of 30
Removing the heater/sensor assembly
Inlets
Agilent 6890 Gas Chromatograph Service Manual
Captured Torx T-20 screw
Upper insulation
Heat sink
Thermal nut
Lower seal
Thrust washer
Reducing nut
Jun 2001