341
Micro-cell Electron Capture Detector (µ-ECD)
Replacement procedures
Mounting bracket
Gang fitting installs here
Ribbon cable
Cover screw
heads with
blank label
Figure 341-10
3.
Peel the blank label from its backing and paste it on the mounting bracket
over the screw heads.
4.
If the tubing from the gang fitting bends to the left, reshape it so that it
bends up and back from the block as shown in Figure 341-12.
14 of 26
(FPD shown above)
Bracket mounted onto the manifold
Detectors
Agilent 6890 Gas Chromatograph Service Manual
Finger-tighten nuts.
Do not use a wrench.
7/16-inch hex nut
ID tag through
slot in bracket
Jun 2001