Agilent Technologies 6890 Series Service Manual page 342

Gas chromatograph

Hide thumbs Also See for 6890 Series:

Table of Contents

Detector assembly

Figure 350-2

Trace the ignitor cable from the FPD to its source on the detector board,

and disconnect it. Note the locations of the signal and high voltage cables,

then remove them from the board.

Replacing the FPD assemblies

Agilent 6890 Gas Chromatograph Service Manual

Flame Photometric Detector (FPD)

Replacement procedures

Type 1 manifold assembly

Valve bracket assembly

Detector PCB

Troubleshooting

6890a 6890 plus