Table of Contents
Advertisement
14.3.3 Trigger Condition Setting (Trigger Mode/Trigger Position)
"Trigger mode" and "Trigger position" in the Trigger condition setting dialog box are set as
follows.
Setting item
Item
Trigger mode
Trigger position
Trigger position:
0
T
Measurement time [EtherCAT communication cycle x Communication cycle magnification x No. of sampling data]
Description
Specifying the timing to log data.
Select
Description
After the start request, the logging is executed only at the time of
Single
the first trigger detection.
After the start request, the logging is executed every time the
Normal
trigger is detected.
After requesting the start, the data before the measurement time
Auto
will be stored as measurement data from the point of time when
the logging stop is requested.
Trigger positions displayed on the time chart monitor can be specified. They can be set
by the rate of the measurement time. Select any one from the following options.
0, 1/8, 2/8, 3/8, 4/8, 5/8, 6/8, 7/8
1/8
2/8
3/8
T
T
T
14.3 Trigger Condition Setting
4/8
5/8
T
T
(0.004 s to 1,044,880 s）
6/8
7/8
1
T
T
14-9
Advertisement
Table of Contents
