Sampling Condition Setting - Panasonic FP0H User Manual

5.3.5 Sampling Condition Setting

 Sampling condition setting
Set the sampling condition. Select "Set" > "Sampling Configurations" in the menu bar to
display the setting screen.
Item Setting range
Mode Trace/Free run
Auto (Starts when PLC
is in RUN mode)
Trace Start
Condition
Manual (Starts trace
from menu)
Logging trigger
Data logging
condition
Bit
Trace stop
condition
Buffer full
No. of samplings
after stop trigger 0-65536
detection
Write file after
completion of ON/OFF
trace
Up to 32 characters can
File name
be set.
Settings
Set a sampling mode.
The trace start condition is automatically set. The trace
operation starts automatically when the PLC enters RUN mode.
The trace start condition is manually set. The trace operation
starts when the trace start button on the time chart monitor is
pressed.
Select a condition to start logging data.
Select this for setting bit conditions as logging trigger. Press the
Bit
"Set" button, and select a device type and a number.
Select this for setting time as logging trigger. Input a cycle for
executing logging.
1 second, 2 seconds, 3 seconds, 4 seconds, 5 seconds, 6
Cycle
seconds, 10 seconds, 15 seconds, 30 seconds, 1 minute, 2
minutes, 3 minutes, 4 minutes 5 minutes, 6 minutes, 10
minutes, 15 minutes, 30 minutes, 1 hour, 2 hours, 3 hours, 4
hours, 6 hours, 12 hours, 24 hours
Trigger conditions occur by executing the F422(LOGSMPL)
Instruction
instruction under arbitrary conditions in user programs.
Set the trigger condition to stop the trace operation.
Set the number of data to be sampled after the detection of the
stop trigger.
Set whether to write data to a file after the completion of the
trace operation or not.
Set a file name in which logged data is stored.
5.3 Trace Monitor (Time Chart)
5-13