6.5.6 Teaching by Tool Operation Function
Activate each axis manually by the tool operation, and register the positioning addresses
where each axis stops as the point data.
PROCEDURE
1. Select "Online" > "Tool Operation" from the menu bar.
The "Tool Operation" dialog box is displayed.
2. Select "Teaching" from the tool operation dialog box.
The "Tool Operation - Teaching" dialog box is displayed.
3. Stop at the positioning point by the JOG operation.
4. Press the [Teaching] button.
5. Input the table number where the desired positioning information is
registered, and click the [OK] button.
The current value is registered for the amount of movement of the table number
specified. Also, if the axis that the teaching operation is performed is an
interpolation axis, the current value is registered for the movement amount of the
equivalent coordinate in the interpolation group.
6. Press [Exit] button to terminate the teaching operation.
6.5 Tool Operation Function of CMI
6-23