9.6 Electronic Cam Function
Adjustment of cam table
There is a function to finely adjust the data of set cam curves in the cam table setting screen.
Rapid change can be lessened by performing find adjustment of the set cam data using the
adjustment function. To perform adjustment, select a section number to be adjusted and press
the [Adjust] button. The adjustment screen is displayed. The adjustment screen shows the
table of the part corresponding to the specified section number among sections divided by the
resolution that all sections (0 to 100%) are set.
Select the data of a phase (control point) you want to adjust and change the displacement
data. Select "OK" to reflect the adjustment. Select "Clear Adjustment" to clear the set
adjustment data. The cam curve of the section number that the adjustment was executed is
displayed in red so that it can be identified.
9-35