Operating Status Leds; Mode Setting Switch - Panasonic FP2 ET-LAN Technical Manual

2.1.2 Operating Status LEDs

ET1 ET2
LED LED
1 1 Connection 1 connected
2 2 Connection 2 connected
3 3 Connection 3 connected
4 4 Connection 4 connected
5 5 Connection 5 connected
6 6 Connection 6 connected
7 7 Connection 7 connected
8 8 Connection 8 connected
Initialization complete
RDY RDY
(communication ready status)
TX TX Transmitting
RX RX Receiving
TEST TEST Test mode
E1 E1 Initialization processing error
System error
E2 E2
Hardware error
ALM ALM CPU fault
100B 100B 100BASE-TX operation
10BT 10BT 10BASE-T operation
10B5 - 10BASE5 operation
12V - 12 V power supply on
RMT RMT Reserved

2.1.3 Mode Setting Switch

Switch No.
1 100BASE-TX/10BASE-T
2 Auto connection function is not available
3 Normal mode
4 Test mode 1
Note1) Switching between 100BASE-TX and 10BASE-T is done automatically by auto negotiation
function. Always turn it off when using AFP27901.
Note2) Invalid when the switch 3 is off.
Key Point:
The settings of the mode setting switches become effective at the point when the power supply is turned
on.
On
Connection 1 fault
Connection 2 fault
Connection 3 fault
Connection 4 fault
Connection 5 fault
Connection 6 fault
Connection 7 fault
Connection 8 fault
Recovery possible error
Warning error
Mail transmission error
Mail reception error
MEWTOCOL error
Auto connection error
Reserved
Off
Note1)
Note2)
Flashing
Connection 1 not connected
Connection 2 not connected
Connection 3 not connected
Connection 4 not connected
Connection 5 not connected
Connection 6 not connected
Connection 7 not connected
Connection 8 not connected
- Initialization not complete
- Not transmitting
- Not receiving
- Normal mode
Normal operation
- Unit normal
- Other mode in operation
- Other mode in operation
- Other mode in operation
- 12 V power supply off
Reserved
10BASE5
Auto connection function is available
Test mode
Note2)
Test mode 2
Off
On
2-3