Specifications
Offset
Name
address
00CH
Dwell time
Auxiliary
00DH
output code
00EH
Reserved for
-01FH
system
16-74
Default
Description
When the positioning operation of this table is finished;
C-point (Continuance
point)
P-point (Pass point)
U0
J-point (Speed control)
E-point (End point)
Range: 0 to 32,767 (ms)
Any other settings will be errors.
Set arbitrary data as auxiliary output codes when using the
U0
auxiliary output function.
-
-
●: Available, -: Not available
The motor stops for the dwell time
and the next operation is started.
It is ignored.
It is ignored.
The positioning done contact turns on
after waiting for the dwell time.
R
W
-
-